Flashing the Receiver:
Fully power the receiver down via the rocker switch at the rear of the receiver.
Make sure no USB devices are plugged into the receiver at this point.
Insert the USB stick containing the image files into one of the USB ports on the receiver.
Power the receiver on from the rear rocker switch and await instruction.
As your Vu+ Uno starts to power up you should see a prompt on the receivers display asking you to press the CH - button, at this point you need to press the channel – or channel down button on the front of the receiver.
IMPORTANT.
DO NOT POWER THE RECEIVER DOWN DURING THE FLASHING PROCESS, AS YOU CAN CAUSE SERIOUS AND PERMANT DAMAGE BY DOING SO.
If you dont see the prompt to press CH - button but instead see the message “starting” it means that the receiver has not detected the USB stick or image files or both. If this happens start from the beginning or try another USB stick, Image or USB port on the receiver.
If all goes well the flashing process should take approximately 2 to 4 minutes to complete, you should now see a message on the display telling you to remove the USB stick and reboot the receiver. Only at this point should you power the receiver on and off to reboot the box.
Please note. you will always see the prompt to press the CH - button if the receiver has detected a viable image to flash on the inserted media at bootup, It is perfectly safe and advisable to keep an
image on your USB stick for backup reasons. The image will only be flashed to the receiver if you press the CH – button when asked to do so, if you ignore the prompt the receiver will boot as normal.
Replies 1
naveenkhan
yes its the right way to do that