How To Flash A VU+ UNO 4K SE Linux Enigma2 Receiver

Flashing the Receiver:

1) Power off the receiver

2) Ensure no other USB devices are plugged into the receiver while flashing.

3) Insert the USB stick containing the image files into one of the usb ports on the receiver, rear usb port is advised if possible.

4) Power the receiver on.

5) As your UNO 4K SE starts to power up you should see a update prompt on the receivers display asking you to press the power button, at this point you touch the power button which is located

6) The receivers display will display various stages of flashing, simply wait for this to complete.

7) If successful the receiver will reboot itself after the flashing process has completed.

8) Remove USB stick that contains the images files.

The flashing process should take approximately two to four minutes to complete, while the receiver is being flashed, it is important that you DO NOT power the receiver down for any reason as this can cause serious or permanent damage.

If the receiver bypasses the flash files on the USB stick and boots into the existing image instead you may need to check that the file structure is correct on the USB stick or try formatting the usb stick using the HP Format tool or try and alternative USB stick.


Like 1

Replies 7

  • Hi...


    The first image that I have installed on my receiver (uno4kse) was black Hole.


    The flashing method was the same as is said in forums....


    About a weak ago, I decide to flash a new image such as OpenATV 6.3 on my receiver....


    I formatted the usb flash drive and send the OpenATV file to it. connect the flash to receiver and turned on the receiver with back key.... after the upgrade message appeared... pressed power to upgrade.


    But it stuck on Flashing Image......


    I tried 3 times more with other images.... Nothing changed.


    At last, during flashing image, after the Flashing image message is appeared, I quickly disconnect and then connect the usb flash drive and it goes on..... and the new image is flashed correctly by this procedure....

    Indeed, I have to do this procedure (quickly disconnect and then connect the usb flash drive when it stuck on Flashing Image) every time I want to flash any new image or backup image.


    I'm using the new usb Flash drive and I format it every time that I want to flash a new image or a backup Image.


    I want know...

    1- What is the problem????

    2- How can I fix it????

  • You use FAT32 formatting?

    Like 1
  • Quote from Newworld

    You use FAT32 formatting?

    Yes

    Like 1

  • Yes You use the format of Fat32 ..... Then your flash Image is installed Correctly.

  • Sometimes a usb stick has some faults, use another USB stick and retry with a Raw image from openatv.

  • Take a USB stick with 2GB, then it should work, with larger ones there are always problems, try both USB ports.


    Switch off the box at the on / off switch at the rear.


    Insert the USB stick, switch the box back on at the on / off switch, then press the "power button" (touch button on the front) within 5 seconds. This will start the flash process

  • sometimes if you are using about all of your receiver memory by having to many plugins etc and try to flash by using a large size USB flash drive, it may cause this kind of problems. As our friend said use a 2gbusb flash drive. Also use different type USB flash drive. Some are not reliable

  • Join the discussion!