Introduction
1. Prepare a USB stick with 1 partition in FAT32
2. Set the default system boot for [enigma2]
3. Create a directory on the pendrive enigma2
4. Copy the uImage and e2jffs2.img a previously created directory enigma2
Upload Image Enigma2:
1. Turn off receiver
2. Connect the USB stick ready to receiver
2. On Front panel hold [OK] and then turn the power switch
3. After about 5 seconds, the display should appear in the display [FORCE] then you should release the [OK] and press [V +]
4. If everything was done correctly the display flashes [U LD] which means that the image is loaded
5. After finishing the upload operation should be released shows [Succ], and the receiver will reboot automatically
