Flashing my AZBox HD Elite

There are 5 replies in this Thread which was already clicked 3,132 times. The last Post () by renshai.

    I am Flashing my AZBox HD Elite but to date cannot put an e2 image on it. I have tried INTERNET via its own internal software and all urls are dead. I tried patch.e2 via usb no joy, my existing Firmware version is 0.9.5309 AZBox Elite HD

    Any suggestions please?

    I've got a version of OpenPli 2.1 on my old AzBox HD.

    It works as well as can be expected.

    I loaded it using Morly's Admin Tool.

    I changed the partition sizes too to make the main one bigger. I also use flash expander with a USB stick. Then there is plenty of space for any extensions.

    Attempting the following but every time I reboot all changes are gone
    all the files I install by Flashfxp disappear on reboot

    Azbox HD Elite
    Firmware version 0.9.5402

    I am following these instructions below to the letter!!!!

    CCcam 2.1.1 Tutorial for AzBox HD



    1. Download and extract on Your PC archive Cccam 2.1.1 AzBox HD.rar



    2. Connect on Your AzBox HD by FTP manager 3. Enter the /EMU directory and transfer there directory lib which is

    located in extracted archive on Your PC. When transfer is finished

    select all files and give CHMOD 755 to them.



    4. Now, enter the OpenXCAS folder on AzBox HD receiver, so You will

    have /EMU/OpenXCAS , and transfer there two files : module.seq and

    openxcas.conf which are located in OpenXCAS folder of extracted

    archive. Give CHMOD 755 to that two files.



    5. Now transfer in /EMU/OpenXCAS folder named as dvbapiCAS which is

    located in OpenXCAs directory of extracted archive. Enter in that

    directory, so You will have /EMU/OpenXCAS/dvbapiCAS and give CHMOD 755

    to 3 files : dvbapi.sh , dvbapi_module and openxcas.conf .



    6. Do not forget to add Your C or N lines to CCcam.cfg file which is located inside of /EMU/lib directory.



    7. After You start dvbapiCAS from Plug-ins -> OpenXCAS -> Camd

    activation & priority , You can test if CCcam is running by

    entering this in Your Web browser : azboxhdip:16001 , in my Case, my AzBox HD in my LAN has IP adress 192.168.1.65, so I am entering 192.168.1.65:16001 .



    That is all for now, with this You have CCcam 2.1.1 Client and Server Installed on Your AzBox HD device

Participate now!

Don’t have an account yet? Register yourself now and be a part of our community!

Register Yourself Login