Hi All Can't get this cam to start in openatv on a uno4k box? Any ideas?
Mgcamd for arm openatv image
- Migz
- Thread is marked as Resolved.
There are 14 replies in this Thread which was already clicked 6,651 times. The last Post () by ahmed gazye.
-
-
Hi All Can't get this cam to start in openatv 6.2 zgemma h7s arm processor
-
You can try this -> Multıcam Manager For Vuplus Arm Based Boxes Only
-
You can try this -> Multıcam Manager For Vuplus Arm Based Boxes Only
Thanks master G but that doesn't work either it tries to start mgcam 1.45 but does not work! ;(
-
How about this version ?
-
How about this version ?
Just tried that version master G still won't start tried the openvix version on openvix image that won't start either! ;( EDit: Has anyone got this to work? Cheers
-
Hi,
I have the same issue, since OpenATV 6.2 has stopped mgcamd
I have tried the other cams for VM - CCCam, Oscam but cannot get these to work!
Help😆
-
Deejayhallam, try it
-
-
Deejayhallam, unzip and see what and where load.
-
They all seem to be old mate
-
hi dones any one have ipk for zgemma h7 box MGcamd for ARM receivers on OpenATV
-
hi dones any one have ipk for zgemma h7 box MGcamd for ARM receivers on OpenATV
Hi, the only way to get MGCamd working with a satellite receiver that has an ARM based processor, is to use the PurE2 image. I hope i am wright
why not use Oscam or CCcam
but you can try mgcamd in attachments
-
Give the attached version a try. May work on version 6.3 and above.
-
try
MGCamd Support Forum
Configs, discussion, downloads and guides for MGCamd Softcam.
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!