Do not look for the truth in people - but look for the truthful
Solving the problem of the appearance of an error message when tweaking the version Neutrino by the Duckba-E2 after the installation of the plugin imagemanager on the external flash
Solving the problem of the appearance of an error message when tweaking the version Neutrino by the Duckba-E2 after the installation of the plugin imagemanager on the external flash
Solving the problem of the appearance of an error message when tweaking the version of Neutrino after installing the plugin imagemanager on the external flash
After installing the version on the plugin imagemanager or j00ztalator program on the external flash card and when entering it via the Duckba-E2 plug-in you may see this message
And his solution, God willing, easy and experienced, I always work when there is this error start on the blessing of God
By using the DCC program, enter the version files by copying any other position on the flash card after installing it
plugin imagemanager on the external flash you will find at the end of a file named boot delte it I am a photographer that the file exists for the explanation but you will find the end files version as the following
After delting the file created Folder and you will be asked to call Fldr poison boot of course did not find a folder named boot files version before it was created as the following
Then via the program dcc transfer the file named uImage, which results in you when decompressing the version Neutrino when you install it via the plugin imagemanager as the following
Then restart the device and then enter the version Neutrino through the DuckBA-E2 or imagemanager , you will find the portal to enter the version successfully I hope to solve the problem and to be a simple explanation and the concept of success, God luck, for all
