My dream 500hd does not communicate with DreamUp when trying to put a flash image.
Anyone see any solution?
There are 33 replies in this Thread which was already clicked 3,951 times. The last Post () by felix dias.
My dream 500hd does not communicate with DreamUp when trying to put a flash image.
Anyone see any solution?
Do you get any error message?
When did you use it last time? Have you made any changed to the PC or the STB or the network since then?
I don't use DreamUp. I used the HTTP client earlier today to re-flash my DM500 HD.
Can you get a Telnet of FTP connection going?
Do you have wired or wireless network connection?
Did you recover it from the bad state it was in earlier? Or is this the same problem still?
Try JapharFlasher (that works with all DM and Sims)
Emo
Try JapharFlasher (that works with all DM and Sims)
Emo
I take it Sims is a receiver brand?
I take it Sims is a receiver brand?
no its a sim card that`s only inside cloned dreambox receivers
I take it Sims is a receiver brand?
no its a sim card that`s only inside cloned dreambox receivers
You can tell how little I know about these things.
Thanks mate!
I did not make any changes.
I can only flash the dream over the internet.
I tried several times with DreamUp and JapharFlasher (with the correct instructions), without any success.
Thank you very much for your help.
I had the same problems with DreamUp but Japhar flasher did work, so perhaps try a few times... ;)
Good luck! :)
My dream 500hd does not communicate with DreamUp when trying to put a flash image.
Anyone see any solution?
if you want to change your image why do you need DreamUP??? , the image is filled through the web interface elementary
or correctly describe the problem you have that covered the loader-( sslxx) to the receiver?
I yet use internet to flash my dream 500HD
Likewise!
However, there are times when one needs DreamUp/Japhar Flasher and it is good to have it and know how it works and that it does work... :)
DreamUp/Japhar Flasher does not work on my dream 500 HD
The latter did on mine, after I followed the procedure carefully... ;)
I followed the procedure carefully in mine... ;)
Oh, I believe you - sometimes it doesn't work... It can be temperamental.
But when I inadvertently flashed my clone with an "original" image - mercifully, it worked when I really needed it to work... :)
Likewise!
However, there are times when one needs DreamUp/Japhar Flasher and it is good to have it and know how it works and that it does work... :)
DreamUp / Japhar Flasher need if you poured in receiver image and you have ERROR NO CA Foundi you need to restore its bootloader.Never yet on my DM500HD(A8P) is not filled in the image using DreamUp. I use the browser Google:rasta2bigsmoke0gf1:
I use the browser Firefox
So do I.
But there is another possibility/error: if you - by mistake - flash your clone box with original image, like I did...
Only Japhar Flasher worked! :)
Don’t have an account yet? Register yourself now and be a part of our community!