Discussion of article How To Flash A VU+ SOLO SE Linux Enigma2 Receiver:
QuoteFlashing the Receiver:Display More
– Fully power the receiver down by the toggle switch at the rear of the receiver.
– Make sure no USB devices are plugged into the receiver at this point.
– Insert the USB stick containing the image files into the USB port on the receiver.
– Power the receiver on.
– The Blue L.E.D will quickly flash two or three times then start to fade in and out slowly.
– Once completed the Blue L.E.D will flash rapidly.
– If in doubt leave the receiver for a full 10 minutes…