I am stuck on 49

old image too ?, start to recovery menu and flash online the same ?

A reset button is hard to see at the back...

Power off

USB in with recovery image

Hold reset button down with ballpoint pen

Power on

Download recovery_emmc.zip for your model receiver

In the extracted file you will see the following files:

• apploader.bin
• bootargs.bin
• fastboot.bin
• imageversion
• usb_update.bin

Copy the above 5 files directly to root of your USB stick.

Ensure your receiver is powered off and connect USB stick to USB port on your receiver.

Gigablue UHD Trio 4K hold down REAR reset button and power on while hold this down.

Once UPDT appears on front screen release reset button or power button, whichever applies to your receiver.

Once booted into the new recovery menu you will see the screen below.

Once completed your receiver will boot into your previously flash image. If the receiver gets stuck on boot it just means you need to flash a new image. Either way

NEW IMAGE HAS TO BE FLASHED.

Due to flash partion re-sizing you now need to flash a new image.

Power off, BUT ENSURE RECOVERY IMAGE FLASHING IS COMPLETED BEFORE POWERING OFF.

Download the image ZIP file for your receiver. Image zip file ends in simply 'mmc.zip'.

Copy the complete 'ZIP' file to root of USB stick, DO NOT UNZIP.

Gigablue UHD Trio 4K hold down REAR reset button and power on while hold this down. Once UPDT appears on front screen release reset button or power button, whichever applies to your receiver.Once booted into the new recovery menu you will see the screen below.

Select 'USB Multiboot Image Upgrade' > Press OK > You'll then see the following screen. At the top you will see the image zip file. In the field below you can select an eMMC slot to flash the image to. For this guide we are selecting Slot 1 where there is currently an OpenViX image installed. We will re-flash this slot. Select 'Start Upgrade' once ready and press OK.

Keep and eye for the Completed notice in screenshot below, appears for couple of seconds only. If miss it, simply press EXIT on your remote for the next step.

In the next screen select 'Multiboot Selector' and press OK.

Select image in STARTUP_1 and press OK, your receiver will now reboot. Flashing process is completed.

I bricked 3 resievers and I dont know what to do...

I brick my boxes all the time. My dinobot 4k went to heaven, but I dragged it back. It was reincarnated as an Anadol 4k.

Most others that are bricked aren't actually bricked. Its just working out what is wrong with them.

I got same problem open atv 6.1...black screen on sky de... and I instaled everything....