TNTSATPC7 config ok + black screen

Quote from Gugo111

..............or everyone has a different encoding of AES Decrypt key

Every provider has it's own 'aeskeys' means those from TNTSAT not work with FRANSAT and visversa ....

and this applies to all other providers (050600, 051900, 060A00,...etc)

so for each provider you have to get their own 'aeskeys'.

;

how to extract the AES Decrypt key from an official receiver that will help me, I need access points JTAG interface points TRST, TDO,TDI,TCK, TMS. processor STiH237 receiver PLUS 1 HD VA PVR (DTS 6923A help me there are also good specialists

here is a photo of the process

remove this radiator carefully .

someone will give me the JTAG interface program STiH237 processor

big apple, if I remove the radiator, I will find the JTAG connection points

Connect the logic analyzer to the correct pins and configure Saleae Logic / PulseView to sniff the initial exchange between the decoder and the board.

To extract (or understand) the AES keys transmitted in clear.

f5103ff8-bde7-4e85-b210-89ddc9580e74.pngIMG-20250409-WA0002.jpg

Quote from samur

Quote from Gugo111

..............or everyone has a different encoding of AES Decrypt key

Every provider has it's own 'aeskeys' means those from TNTSAT not work with FRANSAT and visversa ....

and this applies to all other providers (050600, 051900, 060A00,...etc)

so for each provider you have to get their own 'aeskeys'.

;

Hello samur I've seen that you have compiled a bunch of oscam build on another topic. Thanks for your hard work, it's helping a lot the community.

I would like to ask you something linked to the V7. Do you know if this newer version needs something special on oscam to get it running?

Thanks and good evening

the connection point of logic analyzer is fine, show the photo, do here what you sent is not clear, please help

here's the card_pinout map you'll draw where to connect the logic analyzer help me friend if you can

here's the card_pinout map you'll draw where to connect the logic analyzer help me friend if you can

Hello,

Just tried with two different official receiver.

The v7 card work ok with both of them after a short period of time (pairing process?).

Don’t know if this can help..

I tried with different oscam, status stays the same (ecm are there but black screen).

I’ll check the log if I notice something different from the v6.

Greetings

you should active this card using season interface to obtain your own 3des

as card will store 1st pairing data and will remember .

looking at your post that could be issue with keys not for this card.