Cccam? conflict with 2 E2 boxes on the same LAN

Hi,

Forgive me, as it's probably just a newbie question, but I can't figure out what's going on.

1. I've bought a new box (Dreambox One), so I decided to move my old box (H9S SE) to another room. The moment I power on the second box (H9S SE), my new Dreambox starts freezing (only the channel, not the OS).

I suspect there might be network conflicts related to Webif or perhaps something with the softcam. Should I disable the softcam on the second box?

Any suggestions are welcome.

2. I also have another question regarding streaming to another box on the same network:

Is it possible to stream the satellite signal from the main box to a client box on the same LAN so that the second box can use the satellite signal independently? This way, I'd be able to watch and select different channels instead of being limited to the same channel streamed by the main box.

3. What is the best way to stream between two boxes?

P.S.

The Dreambox One is running OpenBH image, and the Zgemma H9S SE is running EGAMI.

Quote from BernhardC

you use cccam line in home network with original Card or cccam line from a pay server ?

yes, cccam line from a pay server. I disabled cccam/with config line/ in other box and freezing stopped.

Now I am trying to get them sync so i can watch TV in both rooms. Somehow H9S SE/EGAMI/ refused to download Partnerbox and Remote Channel Stream Converter

Quote from master G

Quote from Damian123123

I disabled cccam/with config line/ in other box and freezing stopped

You can`t use the same line on both boxes.

Remote Channel Stream Converter:

what server IP i should I use on main box? random IP or IP of the main box /webif/ ? than obviously copy them to client...

Quote from master G

Quote from Damian123123

what server IP i should I use on main box?

Use the ip address assigned by the router. Same ip you use to connect to openwebif.

Go to the network settings on the main box and set a static ip address by disabling DCHP. If you don`t do this it will be assigned a new ip address every time it gets rebooted or loses connection to the router. Then you`ll need to setup the client box again with the new ip address details.

OK,this part is done and i managed to connect them.

Now on client i have message "no CI found" its obviously oscam but if i turn oscam on freezing starts on main box.

I am using cccam line from pay server so how to set up client so it doesn't cause conflict with master box???