Display MoreHenk,
This morning i plugged in my cypress board and made some screenshots (see screenshots.pdf)
First you can see the device driver an version , the third screen is whith broadcom and the cypress board plugged in
Here i also can't change the revision and i dont have the flash tab.
After that i turned on my VU+ DUO and selected "Flash Explorer", Selected Type Samsung blabla, Pushed Refres , and i got a IO error and the state remaind DISCONNECTED.
I think that when i turned on my vu+ it booted normaly and when it boots normaly it wil disable the JTAG port and i will get the status DISCONNECTED.
So are you absolutely shure that your flash is corrupted or wrongly programmed.
Could you also check if you have output on the serial port , if you plug in a USB stick does the light go on on it
If one of these two above the boot loader works and there is something else wrong
IMPORTAND:
I made a mistake in the cable, in the wrong pin.pdf you can see the mistake
The GND pin was not on the correct pin, but you might have seen that.
Gr
Albert
hello everybody,i have the same problem recoverying my gigablue 800se wich uses the same rules that vu+.When i connect jtag,broadband says connected but suddenly disconnected,all the time connected disconnected and i cant write the boot.Anybody knows why it is making this?Thanks
