Posts by viper18181

Hello all,
Is there a way to make the default installation on the HDD instead of the flash memory for DM800se.

I am running NewEnigma2 3.2.

Thanks a lot really.
Vix with TS panel is great.
I am watching TV with CCCAM now.

Thanks again

Hello.
CCCAM isntalled from VTI Panel.
When I access CAM in the panel, cccam has a check mark next to it and it is on.
I do not think that having it on makes it the default and there is no option when going deeper in VTI panel to make it the default CAM.

BTW, I did not find cccam info too... isn't it included within the cccam complete package?

I would not mind trying a different image that has a ready panel with softcams.
BH was OK and has straight forward option where to make the default cam. I had issues with installing cccam. I did eventually, but it did not clear any channels not i was able to find cccam info.

Let me know if you are aware of any images that are simple and has softcam panel.

Thanks

Hello mate,
You got all possibilities covered.
I have all of the above as you said:
1. very good signal on the channel,
2. my cline is active and working. and of course, one device at the time as my DM800se is off when I am trying to work VU+
3. CCcam.cfg is 100% correct after FTPed to my VU+ Uno etc folder.
4. I suspect that CCCAM is not my default. The question is how to make it the default cam on VTI VU+ Uno??

Thanks for the reply, but that has been done too.. and still not working.
I left a channel on for hours and still did clear.

By the way, when I press the channel info, the banner does not show any cams.
Is that normal?

First, finished introducing myself, I would have done earlier had U known it is required,

Then, I have done what U have said about accessing the blue panel.

What I was hoping for, is that to choose which CAM is the default one, like can be seen on BH images.
It could be the problem.

I am very new to VU+ and so far I have found that there is much less support available on the web as appose to DreamBox.

Anyways,
I have just flashed my VU+ Uno with VTI's latest image and installed cccam and got the cline on cccam.cfg but it is not working.
No channels are clearing. This same cline is working ok on my dreambox 800se.

There is two possibilities,
1. cccam needs to be the default CAM, which I do not know hot to make it the default cam (don't know how to access blue panel)
2. I should not have installed cccam through VTI panel but should have done it manually.

Any suggestions or help would be appreciated.

Regards