How to Flash Enigma2 on Golden Media CR 990 HD LX [Spark]

  • Introduction


    1. Prepare a USB stick with 1 partition in FAT32
    2. Set the default system boot for [enigma2]
    3. Create a directory on the pendrive enigma2
    4. Copy the uImage and e2jffs2.img a previously created directory enigma2

    Upload Image Enigma2:


    1. Turn off receiver
    2. Connect the USB stick ready to receiver
    2. On Frontpanelu hold [OK] and then turn the power switch
    3. After about 5 seconds, the display should appear in the display [FORCE] then you should release the [OK] and press [V +]
    4. If everything was done correctly the display flashes [U LD] which means that the image is loaded.
    5. After finishing the upload operation should be released shows [Succ], and the receiver will reboot automatically

    Please login to see this picture.

  • Discussion of article Please login to see this link.:

    Quote
    Introduction 1. Prepare a USB stick with 1 partition in FAT32 2. Set the default system boot for [enigma2] 3. Create a directory on the pendrive enigma2 4. Copy the uImage and e2jffs2.img a previously created directory enigma2 Upload Image Enigma2: 1. Turn off receiver 2. Connect the USB stick ready to receiver 2. On Front panel hold [OK] and then turn the power switch 3. After about 5 seconds, the display should appear in the display [FORCE] then you…

    Please login to see this picture.